Mevo Gen2 SimKit — Optoma GT2400HDR 1080P Projector + Beaver Tail 4×5.5 Mat
By FlightScope
A Complete Radar-Based Simulator Bay
Around the FlightScope Mevo Gen2
The Mevo Gen2 SimKit pairs FlightScope’s Fusion Tracking launch monitor with the Optoma GT2400HDR 1080P ultra-short-throw laser projector, compact Beaver Tail 4×5.5 hitting mat, and the aluminum enclosure selected at checkout. It is the lowest-priced Mevo Gen2 SimKit in the lineup.
The Mevo Gen2 sits on its included low tripod approximately 7–9 ft behind the golfer, directly on the target line. That rear placement supports seamless right- and left-handed play without moving the monitor. The GT2400HDR is the value-tier display choice for tighter rooms and ambient light, while the compact mat keeps this complete build focused on value.
FlightScope Mevo Gen2 — Fusion Tracking From Behind the Golfer
The Mevo Gen2 uses FlightScope Fusion Tracking: patented 3D Doppler Radar synchronized with image processing. Rather than sitting at the mat or overhead, this compact ground-based monitor sits approximately 7–9 ft behind the ball on the target line. It measures 20 full swing, chipping, and putting parameters directly, with no required subscription for core data.
A built-in laser and camera alignment guide in the FS Golf app helps set tilt, roll, and direction before a session. Its centerline placement also means left- and right-handed golfers can switch without relocating the unit.
Fusion Tracking Accuracy
3D Doppler Radar and synchronized image processing measure ball and club data from behind the golfer.
20 Data Parameters
Full swing, chipping, and putting metrics are directly measured with no required Mevo Gen2 subscription.
Seamless Lefty / Righty
Centered target-line placement means golfers can swap handedness without moving or realigning the unit.
E6 Connect Included
A lifetime E6 Connect bundle with 8 real-world courses ships with the Mevo Gen2.
GSPro & Awesome Golf
Compatible with GSPro on PC and Awesome Golf on PC or iOS for simulator play.
Compact & Portable
At 1.1 lb with USB-C charging and up to 6 hours of battery use, it also travels to the range.
Place the Mevo Gen2 on flat, level flooring approximately 7–9 ft directly behind the ball. Indoor simulator rooms should allow for rear clearance plus ball flight to the screen; about 15–19 ft of total depth is recommended in practice. View the standalone FlightScope Mevo Gen2.
Optoma GT2400HDR — Bright 1080P Value for Tighter Rooms
The GT2400HDR is the value-tier display engine in this Mevo Gen2 lineup. Its 4,200-lumen laser engine supports bright simulator play where ambient light is a concern, while native 1080P resolution keeps course visuals and data clear. The 0.496:1 ultra-short fixed throw is especially suited to tighter rooms when confirmed with the fitment tool.
This projector is a practical budget-friendly choice for a permanent simulator display without stepping into the cost of a 4K upgrade. Its laser light source is rated for up to 30,000 hours.
Native 1080P
1920×1080 Full HD resolution for a clear, immersive image across the impact screen.
4200 Lumens
A bright laser engine that helps the image hold up in rooms with ambient light.
0.496:1 Ultra-Short Throw
Fixed ultra-short throw supports compact room planning and keeps the projector close to the screen.
30,000-Hour Laser Life
Long-life laser illumination avoids routine lamp replacements in a permanent simulator bay.
Three Enclosure Sizes, One Complete Bay
Select the enclosure that fits the room, desired screen width, and depth needed for the Mevo Gen2’s behind-the-golfer placement. All visual selector options use a tool-free aluminum frame. Eagle 12 is the most popular choice; Birdie 10 is the compact option; Albatross 13 makes room for a wider 16:9 display and deeper bay.
Eagle 12 Enclosure
Wide enough for a generous 4:3 screen, while its 60″ enclosure depth fits common two-car garage bays. This configuration includes a 6×12 landing mat.
Birdie 10 Enclosure
The compact 120″-wide 4:3 enclosure for narrower rooms, basement lanes, and single-car garage bays. This configuration includes a 6×12 landing mat.
Albatross 13 Enclosure
The widest option uses a 16:9 screen, 72″ enclosure depth, and a larger 6×15 landing mat. Choose it when the room has depth to support the radar rear clearance and a cinema-scale image.
Enclosure dimensions are only part of the plan. Confirm ceiling height and the GT2400HDR location with the Projector Fitment Tool, then reserve the 7–9 ft rear space required by the Mevo Gen2.
Beaver Tail 4×5.5 — Compact, Replaceable, Value-Focused
This is the only Mevo Gen2 SimKit paired with the compact Beaver Tail 4×5.5 hitting mat rather than the 4×8.25 double-wide. Its smaller single-sided footprint makes room planning simpler and helps keep the package at the lowest price point in the Mevo Gen2 SimKit lineup.
The Mevo Gen2 sits behind the golfer, so the front of the mat and ball flight stay clear while rear space is reserved for the radar. The mat’s replaceable hitting strip is designed for realistic, joint-friendly practice over long sessions.
4×5.5 Footprint
Compact single-sided stance platform for value-focused rooms and tighter simulator bays.
Replaceable Hitting Strip
Replace the wear surface rather than the full mat when the hitting strip reaches the end of its service life.
Joint-Friendly Feel
The realistic insert is designed to soften the impact of repeated practice swings.
Stable Bay Surface
Dense construction stays flat through full swings and pairs with the landing mat at the enclosure base.
Birdie 10 and Eagle 12 include a 6×12 landing mat. Albatross 13 includes a 6×15 landing mat. View the Beaver Tail 4×5.5 hitting mat.
Mevo Gen2 SimKit — Eagle 12 Bay
Eagle 12 enclosure shown. Photography illustrates the enclosure environment; Mevo Gen2 rear placement and any putting green are not shown. Putting green is not included in the standard SimKit.
What Completes the Build
The monitor, projector, enclosure, and hitting mat form the primary package. Included accessories support a cleaner installation and a properly finished landing area.
Projector Install Kit
BenQ CM00G3 ceiling mount, 25ft HDMI cable, and 25ft power cable for a clean projector installation.
Landing Mat
Automatically sized to the selected enclosure: 6×12 with Birdie 10 or Eagle 12, and 6×15 with Albatross 13.
Mevo Gen2 Setup Kit
The launch monitor ships with its low tripod / kickstand, USB-C cable and power supply, carry case, quickstart guide, and aluminum spin sticker sheet.
What’s In The Box
- FlightScope Mevo Gen2 Launch Monitor
- Optoma GT2400HDR 1080P projector
- Enclosure selected at checkout
- Beaver Tail 4×5.5 hitting mat
- BenQ CM00G3 ceiling mount
- 25ft HDMI cable and 25ft power cable
- Landing mat: 6×12 or 6×15 by enclosure
- Mevo Gen2 tripod, USB-C cable, power supply, carry case, and spin stickers
- Lifetime E6 Connect bundle with 8 courses
- Windows PC for GSPro or Awesome Golf (PC)
- Putting green, optional at checkout
- FlightScope Pro Package and Face Impact Location upgrades
SimKit Quick Specs
| Pricing | Varies by enclosure — see variant selector above |
| Launch Monitor | FlightScope Mevo Gen2 (retail $1,299.00) |
| Tracking | Fusion Tracking: 3D Doppler Radar + image processing |
| Monitor Placement | Ground-based, approximately 7–9 ft behind the ball |
| Data Parameters | 20 across full swing, chipping, and putting |
| Software | E6 Connect, GSPro (PC), Awesome Golf (PC & iOS) |
| Projector | Optoma GT2400HDR, 1080P, 4200 lumens |
| Projector Throw | 0.496:1 ultra-short fixed throw; confirm with Fitment Tool |
| Laser Life | Up to 30,000 hours |
| Hitting Mat | Beaver Tail 4×5.5 compact single-sided mat |
| Landing Mat | 6×12 for Birdie 10 / Eagle 12; 6×15 for Albatross 13 |
| Shipping | Free UPS Ground, Continental US |
Why Choose This SimKit?
- Lowest-priced entry point in the Mevo Gen2 SimKit lineup
- 4,200-lumen ultra-short-throw projector for bright, tighter-room builds
- Radar placement behind the golfer enables seamless lefty / righty switching
- Compact Beaver Tail 4×5.5 mat keeps the initial build focused on value
Who This SimKit Is Built For
The Value Builder
Wants a complete Mevo Gen2 simulator bay at the lowest package price without leaving out the enclosure, projector, or hitting surface.
The Tighter-Room Planner
Needs a bright ultra-short-throw projector option and is prepared to confirm the GT2400HDR with the fitment tool.
The Shared Bay Golfer
Benefits from a target-line radar monitor that does not move when right- and left-handed golfers alternate.
The Compact-Mat Buyer
Prefers the space-conscious 4×5.5 Beaver Tail over the larger double-wide mat in the step-up Mevo Gen2 kits.
Build Your Own or Step Up the Display
This GT2400HDR package is the value entry point. Compare Mevo Gen2 builds with a step-up 1080P projector or a 4K projector, select every component individually, or consider another launch monitor platform.
Step-Up 1080P: BenQ AH700ST
Move to the Mevo Gen2 AH700ST SimKit for another 1080P laser option and the larger Beaver Tail 4×8.25 double-wide mat.
View AH700ST Mevo Gen2 SimKit4K Upgrade: BenQ AK700ST
Choose the Mevo Gen2 AK700ST SimKit for 4K display resolution and the double-wide Beaver Tail 4×8.25 mat.
View AK700ST Mevo Gen2 SimKitBuild Your Own SimKit
Select a different launch monitor, projector, enclosure, or hitting mat in a custom component-by-component build.
Open the Bundle BuilderGarmin R50 SimKit
Consider Garmin R50 as an alternate launch monitor option with its own built-in touchscreen simulator experience.
View Garmin R50 SimKitResources
Mevo Gen2 SimKit — FAQ
The ESG Advantage
A complete simulator package is easier to plan when the core components, enclosure options, and installation accessories are considered as one build.
Configured for a Complete Bay
The Mevo Gen2, GT2400HDR, enclosure, compact Beaver Tail mat, mount, cables, and landing mat are organized as one coordinated package.
Value Without Guesswork
This is the lowest-priced Mevo Gen2 SimKit configuration, with pricing and enclosure options clearly separated for room planning.
ESG-Backed Support
Post-purchase setup and software guidance is available for projector planning, monitor alignment, and simulator software configuration.
