Carl's Place Frame-Mount Projector Mounting Kit
By Carl's Place
Mount a Projector Directly to Pro Enclosure Framing
This kit mounts a projector to the framing of a Carl’s Place Pro Enclosure using an included bracket, removing the need to anchor into ceiling joists. Two adjustment knobs set tilt, roll, and swivel by hand or with a screwdriver, and cabling routes through the mount.
Frame Mounted Projector Alignment
No Ceiling Work
Mounts to the enclosure frame instead of the ceiling. Useful in garages and finished rooms where joist access is limited.
Hand Adjustable
Two knobs control tilt and roll and allow swivel. Adjust by hand or with a screwdriver during image alignment.
50 lb Capacity
Supports projectors up to 50 lb, which covers virtually every short-throw and 4K laser projector used in simulator builds.
Adjustable Reach
The plate extends up to 17.63″, giving room to set throw distance relative to the screen.
Universal Pattern
Fits most projector mounting patterns rather than a single model.
Clean Cable Run
Cabling routes through the mount for a finished look rather than hanging below the projector.
Mount Specifications
| Load capacity | Up to 50 lb |
|---|---|
| Maximum plate extension | 17.63″ |
| Adjustment | Tilt and roll via two knobs, plus swivel |
| Adjustment method | By hand or with a screwdriver |
| Projector compatibility | Fits most projectors |
| Cable management | Routes through the mount |
| Mounting surface | Carl’s Place Pro Enclosure framing |
| Bracket | Included |
Confirm Throw Distance First
Throw distance drives image size and keystone correction. Verify the mounting position against the projector’s throw ratio and the screen dimensions before drilling or committing to a bracket position.
Use the Projector Fitment ToolCheck Projector Fitment Before Ordering
Fitment questions, ceiling height checks, and compatibility confirmations are handled before the order ships.
Contact UsFrequently Asked Questions
What does this mount to?
The framing of a Carl’s Place Pro Enclosure. It does not require ceiling joist anchoring.
How much weight does it hold?
Up to 50 lb, which covers essentially all short-throw and 4K laser simulator projectors.
How far does the plate extend?
Up to 17.63″.
Can the image be aligned after mounting?
Yes. Two knobs adjust tilt and roll and allow swivel, by hand or with a screwdriver.
Does it fit my projector?
The mount fits most projector mounting patterns. Confirm your projector’s bolt pattern and weight against the 50 lb limit.
Is a bracket included?
Yes, the mounting bracket is included.