Carl's Adjustable Floor Wedges for Projectors, Set of 2
By Carl's Place
Tilt a Floor Mounted Projector Into Alignment
A floor mounted projector often will not line up with the bottom of the impact screen because of its vertical offset. These wedges prop the rear corners of the projector to create the tilt needed to bring the projected image down into position. Sold as a set of two.
A Gentle Slope Under the Rear Corners
Fixes Offset Misalignment
Corrects the gap between the projected image and the bottom of the impact screen caused by projector vertical offset.
Simple Adjustment
Raise the rear of the projector to move the image lower. Sliding the wedges changes the angle without tools.
Black ABS Plastic
Molded black ABS keeps the wedges rigid under projector weight and visually recessive inside a floor enclosure.
Enclosure Compatible
Designed to work inside Carl’s Floor Mounted Projector Enclosure alongside a floor mounted projector.
No Hardware Needed
The wedges sit under the projector feet. No drilling, brackets, or fasteners.
Sold as a Pair
Two wedges per set, one for each rear corner.
Wedge Specifications
| Quantity | Set of 2 |
|---|---|
| Length | 9.125″ |
| Width | 2.375″ |
| Angled height | Up to 2″ |
| Material | Black ABS plastic |
| Compatibility | Golf simulator projectors used inside a Carl’s Floor Mounted Projector Enclosure |
| Installation | Placed under the rear corners of the projector |
Confirm Throw and Offset
Wedges correct modest offset mismatch. If the image is far out of position, the projector distance itself likely needs to change. Verify throw distance and offset before relying on tilt alone.
Use the Projector Fitment ToolDial In the Projected Image
Fitment questions, ceiling height checks, and compatibility confirmations are handled before the order ships.
Contact UsFrequently Asked Questions
How many wedges come in a set?
Two, one for each rear corner of the projector.
What are the dimensions?
9.125″ long by 2.375″ wide with up to 2″ of angled height.
What material are they?
Black ABS plastic.
Which projectors do they work with?
They are compatible with golf simulator projectors used inside Carl’s Floor Mounted Projector Enclosure.
Which direction do I tilt?
Raising the back of the projector moves the projected image lower on the screen.
Do I need tools?
No. The wedges sit under the projector feet and are repositioned by hand.